Skip to content

First Job - Introduction

What you'll learn

This guide walks you through setting up and running your first PCB assembly job using the Getting Started Kit, included with the LumenPnP.

Before starting, ensure you've completed the Calibration guide to get your LumenPnP up and running. Proper calibration is needed for accurate part placement.

This guide isn’t just for first-time setup. You’ll revisit these steps whenever you start a new board until you have the process memorized. The process becomes much faster with experience, so take your time on your first run to build a solid understanding.

Tutorial Video

This video walks you through the process of running your first job on the LumenPnP. Each page in this section has a link to the relevant timestamp of the video.

What you'll need

A fully assembled and calibrated LumenPnP.

OpenPnP installed and configured on your computer.

The "Getting Started Kit" with:

  • A FTP PCB
  • 0603 Resistors
  • Universal Mounting Kit prints and hardware
  • 8mm strip feeder

Next Step

Now that you have everything ready, let’s start by setting up your board.